Bard WUVCLP-A - Manual (Page 6)

Page 6
4. Remove the exterior blower access panel from the wall mount unit and set it aside. (See
Figure 2)
5. Using the top screw hole for the blower door panel as a starting point, drill two ¼ inch
holes on each side of the unit to secure the mounting brackets of the WUVCLP. See
Figure 3 for hole locations.
6. Place the WUVCLP light assembly in the unit 1”
below the top of the unit. Insert two self drilling
screws on the right side of the unit and into the right
side mounting bracket of the WUVCLP light
assembly. Use the pilot holes in the mounting
brackets for alignment. (See Figure 4)
Figure 2
Figure 3
Figure 4