AEM 30-3500 Infinity Plug & Play Harnesses - Toyota 1993-1997 Supra Turbo - Manual (Page 18)

18
© 2014 AEM Performance Electronics
P/N 30-3500
Infinity
Pin
Hardware Reference
7100-XXXX-62
7101-XXXX-63
Function
Hardware Specification Notes
C1-35 Analog_In_7
Throttle Position
Sensor
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU. See the
Setup Wizard Set Throttle Range page f or
automatic min/max calibration. Monitor the
Throttle [%] channel. Also DB1_TPSA [%]
f or DBW applications.
C1-36 Analog_In_8 MAP Sensor 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU. See the
Setup Wizard Set Manif old Pressure page
f or setup and calibration. Monitor the MAP
[kPa] channel.
C1-37 Analog_In_9 Fuel Pressure 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU. See the
Setup Wizard Fuel Pressure page f or setup
and calibration. Monitor the FuelPressure
[psig] channel.
C1-38 Analog_In_10 Baro Sensor 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU. See the
Setup Wizard Barometric Pressure page
f or setup and calibration. Monitor the
BaroPress [kPa] channel.
C1-39 Analog_In_11 Shif t Switch Input 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU.
See the 1D lookup table 'Shif tSwitch' f or
setup. Also assignable to multiple
f unctions. See Setup Wizard f or details.
C1-40 Analog_In_12 Mode Switch 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can
permanently damage the ECU.
See the 1D lookup table 'ModeSwitch' f or
input state.
A multi-position rotary switch such as AEM
P/N 30-2056 is recommended.
Also assignable to multiple f unctions. See
Setup Wizard f or details.