AEM 30-3508 Infinity Plug & Play Harnesses - Honda 2000-2005 S2000 - Manual (Page 4)

4
© 2014 AEM Performance Electronics
P/N 30-3508
INFINITY ADAPTER HARNESS
Included with the 2000 – 2005 Honda S2000 kit is an adapter harness. This is used to make the
connection between the AEM Infinity EMS and the Honda wiring harness plug and play. This is depicted
below with the 80-pin connector and the Honda header. There are also a few other integrated connectors
within this harness described below.
The gray Deutsch 6P DTM “Lambda #1” connector is for connecting a UEGO wideband Bosch LSU4.2
sensor (AEM 30-2001). The UEGO extension harness (AEM 30-3600) mates the adapter harness to the
sensor.
The gray Deutsch 4P DTM connector is used for “AEMNet”. AEMNet is an open architecture based on
CAN 2.0 which provides the ability for multiple enabled devices, such as dashboards, data loggers, etc.,
to easily communicate with one another through two twisted cables (CAN+/CAN-).
The black Delphi 2-pin “Flash Enable” connector is used for secondary hardware flashing. The included
shunt connector jumps the 2 wires together. Once initially flashed, the EMS is normally upgraded in the
software, not using this connector.
The gray Deutsch 12P DTM “Auxiliary” connector
(shown below) is used to adapt many common
ancillary inputs and outputs easily. Included in the kit
are a DTM 12P mating connector, 12 DTM terminals,
and a DTM 12P wedgelock. If used, these
components will need to be terminated by the installer
or end user with 16
– 22awg wire (not included). Note:
The pin numbering is molded into the connector, as
shown.