AEM 30-5141 Analog H2O Flow Gauge - Manual (Page 6)

Page 6
Specifications
Gauge
Supply Current
0.1 A
Differential Analog Outputs 1
Measuring Range 0-500 cc/min
0-7.93 gal/hr
Operating Voltage (nominal) 8.5-15 volts dc
Harness & Connector Temp Limit: 105C
Notes
The sensor is a precision pressure measuring device and should not be subject to
mechanical or thermal shock or it may be damaged.
If further tuning help is needed be sure to visit the video gallery or performance
electronics forum at www.aempower.com for comprehensive instructional videos and
information.
Replacement Components
35-3411
8-Pin Power Harness
35-3415 3-Pin Sensor Harness
35-2126 Flow Sensor
Important Safety Notice Regarding Methanol
AEM strongly recommends that users never exceed a 50% methanol
concentration when using any AEM Water Methanol system or component.
All AEM Water/Meth injection systems and components (pump, lines, fittings, filter, flow
sensor, tank, and nozzles) are 100% chemically compatible with methanol. However, for
safety reasons we strongly recommend that users never use more than a 50%
methanol concentration in our systems.
Methanol is a toxic and highly flammable chemical. 100% Methanol ignites easily and
burns vigorously with an almost undetectable flame. Methanol can be absorbed through
the skin and even small amounts can cause blindness or even death. Using this fluid at
high pressures, without dilution, in an under-hood environment with nylon lines and
push-to-connect fittings is very unsafe. The performance advantages of using greater
than 50% methanol concentrations are small, if they exist at all. However, the safety
issues are very real and far out weigh any perceived benefit of running high
concentrations of methanol.
Note: AEM holds no responsibility for any engine damage or personal injury that
results from the misuse of this product, including but not limited to injury or
death caused by the mishandling of methanol.