AEM 30-5144 Analog Boost Fuel Pressure SAE Gauge - Manual

AEM Performance Electronics
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-5144 Rev 01

2010 AEM Performance Electronics
Part Number 30-5144
Analog Style 15 PSI Fuel/Boost Pressure Gauge
NOTE: Faceplate Configuration Instructions Included on Separate Sheet
Figure 1. Wiring Schematic
AEM Oil/Fuel Pressure Gauge Parts
1 x 35-5144 Pressure Gauge Assembly
1 x 30-2131-15 PSIG Pressure Sensor
1 x 35-4302 Install Kit (6 Butt Connectors)
1 x 10-5144 Installation Instructions
1 x 35-3411 8-Pin Power Harness
1 x 35-3412 3-Pin Sensor Harness
1 x 35-8529S Silver Bezel
1 x 35-8550W Fuel Pressure Faceplate, White
1 x 35-8551B Boost Pressure Faceplate, Black
1 x 35-8551W Boost Pressure Faceplate, White
1 x Faceplate Configuration Instructions
1 x Paper Clip Needle Removal Tool
1 x 35-
2151 1/8” NPT Female Hose Adapter
1 x 35-2149 Boost Tee
1 x 8-
161 36” Vacuum Hose
4 x 1-117 Zip Tie
CAUTION:
When working with the fuel system, choose a suitable
work area that is well ventilated and free from any
sparks or open flames. Do not smoke while working
on the fuel system. Most fuel systems remain
pressurized for a period of time, after the key has been
turned off. Be sure to relieve the pressure before
installing the sensor. This can often be accomplished
by removing the fuel pump fuse and cranking/running
the engine.