Important application specific settings, Engine, Cam/crank – AEM Infinity Supported Applications - Dodge HEMI Engine User Manual
Page 3: Injector setup, Input functions, Output functions, Ignition sync, Infinity tuner wizard setup engine
Infinity Supported Application
3
© 2014 AEM Performance Electronics
IMPORTANT APPLICATION SPECIFIC SETTINGS
Infinity Tuner Wizard Setup
Engine
In the Wizard Engine tab confirm the following settings:
Number of Cylinders
= 8
Engine Cycle Type
= 4 Stroke
Ignition Type
= Sequential (Coil On Plug)
Firing Order
= 1-8-4-3-6-5-7-2
Cam/Crank
In the Wizard Cam/Crank tab confirm the following setting:
Dodge Hemi V8 (2005–2008)
Injector Setup
In the Wizard Injector Setup tab confirm the following setting:
Number of Injectors = 8
Input Functions
In the Wizard Input Functions tab confirm the following setting:
AC Input Switch Setup = AC_Req_dig
Output Functions
In the Wizard Output Functions tab confirm the following setting:
LowSide 8 Setup = MILOutput or EngineProtectOut
Ignition Sync
** NOTE: These settings are applicable to firmware release v95 and greater only.**
Add a text grid control to your layout and select the following channels. Make sure their values match
the settings below for initial timing sync.
TrigOffset [degBTDC]
= 24.00
CamSyncAdjustment
= 18.00
See QuickStart Guide section Setup: Ignition Sync for instructions on timing sync.