AEM Infinity Supported Applications - Mitsubishi 1990-1994 4G63 Engine - Manual (Page 11)

Infinity Supported Application 11
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest. Pin
1G DSM
Hardware Specification Notes
C1-36 Analog_In_8 MAP Sensor 12 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU. See the Setup Wizard
Set Manif old Pressure page f or setup and
calibration. Monitor the MAP [kPa] channel.
C1-37 Analog_In_9 Fuel Pressure 57 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU. See the Setup Wizard
Fuel Pressure page f or setup and
calibration. Monitor the FuelPressure [psig]
channel.
C1-38 Analog_In_10 Baro Sensor 16 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU. See the Setup Wizard
Barometric Pressure page f or setup and
calibration. Monitor the BaroPress [kPa]
channel.
C1-39 Analog_In_11
Shif t Switch
Input
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU.
See the 1D lookup table 'Shif tSwitch' f or
setup. Also assignable to multiple
f unctions. See Setup Wizard f or details.
C1-40 Analog_In_12 Mode Switch 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as
the low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU.
See the 1D lookup table 'ModeSwitch' f or
input state.
A multi-position rotary switch such as AEM
P/N 30-2056 is recommended.
Also assignable to multiple f unctions. See
Setup Wizard f or details.
C1-41 +5V_Out_1 +5V Out
Regulated, f used +5V supply
f or sensor power
Analog sensor power
C1-42 +5V_Out_1 +5V Out 23
Regulated, f used +5V supply
f or sensor power
Analog sensor power
C1-43 HighsideSwitch_1
HS1 (switched
12V)
0.7A max, High Side Solid State
Relay
See Setup Wizard page 'HighSide
Assigment Tables' f or conf iguration
options.
See 2D lookup table 'HS1_Table' f or
activ ation settings.