General information – SCT X3 ECONOMIZER (Ford 3030) User Manual
Page 3
GENERAL INFORMATION
The X3 Economizer is pre-programmed for use on the following vehicles:
•
1996—2007 V-8 Mustangs and Cobras
•
2007—2008 Shelby GT500 Mustang
•
1994—2007 V-6 Mustangs
•
2003—2007 F-Series 6.0L Diesel Trucks
•
1999—2003 F-Series 7.3L Diesel Trucks
•
1997—2003 F-Series 4.6L / 5.4L Gas Trucks
•
2004—2006 F-Series 4.2L / 4.6L / 5.4L / 6.8L Gas Trucks
•
1999—2004 Focus SVT / Zetec
•
2003—2004 Mercury Marauder
•
1999—2004 Crown Victoria
•
2005—2008 Crown Victoria
•
2002—2005 Thunderbird
•
2000—2006 Lincoln LS w/ V-8
•
1996—1999 Taurus SHO
•
1999—2005 Excursion Diesel / Gas
•
1996—2006 Explorer 4.0L / 4.6L / 5.0L
•
1997—2006 Expedition 4.6L / 5.4L
•
1999—2008 Econoline Series Vans 4.2L / 4.6L / 5.4L / 6.8L Gas Trucks
Available Gasoline Tunes: Fuel Economy Only.
Available diesel tunes: Fuel Economy Only.
Note:
Not all options are available for all vehicles.
X3 Economizer VIN locks to a single vehicle. You cannot use the device to tune a new or
different vehicle, until you have returned the original vehicle back to stock, which will unlock
the device. You can only change vehicles 5 times before the unit is permanently locked.
Both firmware and software updates will be made available periodically for the X3
Economizer and are available in the “Support” section of the SCT website—www.sctflash.com
The manufacturer, SCT, will offer periodic firmware updates that effect the operation of the
device or tune revision updates to maintain CARB and EPA compliance based on updates to
federal or state regulations regarding emissions.