JB Conversions 16-1201 HD Super Short SYE Kit for the NP231J - Manual (Page 9)

9
17) Install the new, rear bearing housing into position. Apply grease to
the seal lip before lowering the housing into place (Fig.16).
FIG: 16
18) Apply a small amount of RTV to the backside of the nut and in the
threads before tightening. Install the 5, 8mm bolts to hold the rear
housing in place. Install the yoke and nut as shown. Torque to 200 lb-
ft. (Fig.17). This kit does not utilize a rubber star washer beneath the
nut.
NOTE: If you experience an erratic speedometer needle, this is an
indication that the nut is insufficiently torqued. Retorque to
recommended amount.
FIG: 17