Best K29 - Manual (Page 5)

- 5 -
FUSE REPLACEMENT
IF THE LIGHTS FAIL TO OPERATE, DISCON-
NECT THE POWER AT THE SERVICE EN-
TRANCE. CHECK THE FUSE AND RE-
PLACE IF NECESSARY.
1. Remove the filters.
2. Remove the electrical box support.
3. Remove screws from the fuse box and
open the cover.
4. Locate the fuse holder. Unscrew its cap
and remove the fuse.
5. Replace the fuse with the same size and
amperage (5 x 20mm, 4A, 125V).
6. Reinstall the fuse box cover, electrical box
support, and filters.
7. Reconnect power at the service entrance.
MAINTENANCE
Grease Filters
The grease filters should be cleaned frequently. Use a warm detergent
solution to clean filters. Filters are dishwasher safe. See “INSTALL FILTER”
section for installation and removal instructions.
Ductfree Filters
The ductfree filter should be changed every 6 months. See “INSTALL FILTER”
section for installation and removal instructions.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will
help preserve its fine appearance.
Cleaning tips:
• Hot water with soap or detergent is all that is usually needed.
• Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth
to avoid water marks.
• For discolorations or deposits that persist, use a non-scratching household
cleanser or stainless steel polishing powder with a little water and a soft cloth.
• For stubborn cases, use a plastic scouring pad or soft bristle brush together
with cleanser and water. Rub lightly in direction of polishing lines or "grain" of
the stainless finish. Avoid using too much pressure which may mar the surface.
• DO NOT allow deposits to remain for long periods of time.
• DO NOT use ordinary steel wool or steel brushes. Small bits of steel may
adhere to the surface causing rust.
• DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds
to remain in contact with stainless steel for extended periods. Many of these
compounds contain chemicals which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
ELECTRICAL
BOX
SUPPORT
FUSE
FUSE BOX