Best K29 - Manual (Page 8)

- 8 -
INSTALL FLUE MOUNTING
BRACKET
1. Carefully center the mounting bracket di-
rectly over the range hood location.
2. Secure the bracket assembly to the ceiling
using (2) 4.8x38mm mounting screws and
drywall anchors. Make sure the bracket is
pushed into the corner, tight against the
wall and centered over the hood.
FLUE
MOUNTING
BRACKET
PREPARE THE HOOD
DUCTED CONFIGURATION ONLY
Note: On stainless steel hoods, carefully
remove the plastic protective film from all
exterior surfaces of the hood and decora-
tive flues, prior to final installation.
1. Attach an adequate length of 6” round
metal duct to the range hood duct connec-
tor.
2. Duct tape all joints to make them secure
and air tight.
3. Carefully place the lower decorative flue
into the recessed area of the range hood
top.
4. Carefully slide the upper decorative flue
down inside the lower flue.
Note: On 8' ceilings the air vents on the upper
flue are concealed by installing the flue with
air vents down.
On 9' ceilings, air vents on the upper flue will
be exposed after installation.
6” DIAMETER
METAL DUCT
DUCT
CONNECTOR
UPPER
FLUE
LOWER
FLUE
UPPER
FLUE
VENTS
EXPOSED
LOWER
FLUE
VENTS
CONCEALED