Brookstone Virtual Keyboard 796246 - Manual (Page 18)

AdjuStINg KeY StrOKe SOuNd leVel
Press and hold FN key and press S key . Continually pressing the FN key and
pressing the S key will cycle through all available sound levels . There are 4 levels of
sound, including mute . You will see your current sound level displayed on the screen .
The sound level remains as adjusted when device is turned off and on .
Note: Please consider those around you when adjusting sound level.
AdjuStINg KeYBOArd BrIgHtNeSS
Press and hold FN key and press B key . Continually pressing the FN key and
pressing the B key will cycle through all available brightness levels . There are 4 levels
of brightness . You will see your current brightness level displayed on the screen .
Note: fN key is not a repeat key. fN key must be clicked once for each adjustment.
CAlIBrAtINg
(trOuBleSHOOtINg)
Important: The Virtual Keyboard comes ready to use, however, if you find the keys
are not reacting as expected, follow the steps below to calibrate your keyboard .
1 . Press the FN button and tap the C key twice . The screen will go in to calibration
mode . Alternatively holding the On/Off button down for 10 seconds after device
is powered on, will also go into calibration mode .
2 . The screen will display 2 flashing icons . Press the function keys (F1 and F12) .
Hold your fingers down on the keys, the unit will show 2 icons flashing at the
top, until you hear a beep .
3 . The screen will now show 2 icons flashing at the bottom of the unit . Press
the bottom outside keys (FN and arrow right) . Hold your fingers down on the
keys until you hear a beep .
4 . The screen will then go back to the home screen as calibration of the unit has
been completed .
5 . If the keys are still being incorrectly recognized, try calibrating again .
17