Brookstone Virtual Keyboard 796246 - Manual (Page 19)

18
Note: to exit calibration mode at any time, press the fN and C key, again.
No calibration information will be saved until the entire calibration mode has
been completed.
QuICK KeY refereNCe guIde
Bluetooth:
1 . Searching Last Device (Bluetooth icon blinking) .
2 . Searching New Device (Bluetooth icon blinking) .
3 . Successful Pairing (Bluetooth icon solid) .
4 . Disconnected (Bluetooth icon not visible) .
uSB Connection: U will be displayed when USB cord is plugged into computer .
Bluetooth will have preference over the USB connection . Press FN and W on the
Virtual Keyboard to override and connect to USB, even when a previously paired
Bluetooth device is in range .
Adjusting Sound (FN and S): Volume level bars will appear .
Adjusting Key-press Sensitivity (FN and K): Sensitivity level bars will appear .
Adjusting Brightness (FN and B): Brightness level bars will appear .
Calibration (FN and C): Must press C twice – or holding on/off for 10 seconds
1 . Shows two icons on top flashing for user to hold the F1 and F12 keys on the
first row (beeps for success) . Hold down finger for 3 seconds .
2 . Shows two icons on bottom flashing for user to press the outside keys on the
bottom row (FN and right arrow) . Hold down fingers for 3 seconds (beeps for
success) then goes back to home screen .
79
62
4
6_
IN
S
_V
irt
ua
l K
ey
bo
ar
d
S
iz
e:
5”
W
x4
.7
5”
H
_O
ut
pu
t:1
00
%
_P
rin
ts
:1
/1
,B
lk