Baby Trend Walker WK37 - Manual (Page 3)

2
ASSEMBLY
PARTS
1. Unpack all contents and please check that all parts are present before
starting assembly. Please see PARTS.
2. To open the baby walker raise the tray to the middle position as shown in
figure 1.
3. Insert the plastic pins on the front of the seat into the holes, then click the
pins into position by pushing them downwards shown in figure 2.
4. Locate the straps with plastic buckles on back of seat and corresponding
slots on tray. Insert each strap into corresponding slot. From underside of
tray pull each strap completely through each slot and pivot plastic buckle
to lay flat against underside of tray. As shown in figure 3 and 3A.
5. Place walker on a solid flat surface with bottom of base facing upward.
Insert the pins of the wheels into their housing, pressing them until they
snap into position. Please check that wheels are locked into place as shown
in figure 4 and 5.
6. Thread the end of the support strap through the loop on the seat bottom and
then through the slot at the end of the height adjustment bracket found
under the tray as shown in figure 6. Next thread the support strap through
the opening in the rectangular ring and pull snug as shown in figure 7.
Fig. 1
Fig. 2
Toy Bar
Seat
Wheels
front rear
Fig. 4
Fig. 3
Fig. 3A
Fig. 5 Fig. 6 Fig. 7
FRONT
REAR
Base