Road Armor 2008-2011 Chevy Rear Bumper - Manual (Page 3)

Place the trailer mount
tab in the same position
as illustrated. You are go-
ing to need to bend the
small tab away from you.
Use a socket to help
push on the retainer
washer.
Note - if you have a 2011 2500 / 3500..
• Use the 14mm OEM bolt and supplied nut to bolt the frame to the hitch. Make sure the
bolt goes down into the frame so the threads are facing down and tighten. Photo 9
• Depending on the model of truck you may need to use the additional frame mount
plate so the mount sits parallel to the frame. Photo 7 - 8
• Install the bumper mount as shown in pictures using 1/2” hardware. You will need
someone that does not have a big forearm to push the 1/2” bolt through the frame
from the access hole in the frame. See picture 10 - 12
• Do not tighten down frame bracket hardware.
• Continue with step 3
• Once bumper is tight crank spare tire into place. Picture 13
• Carefully guide bumper onto brackets and snug down the hardware but not tight enough to
where you cannot move the bumper around.
• Square the bumper up with the bottom of the tail gate and the sides of the body. Be sure to
check clearance when opening tailgate (be cautious when doing this).
• Tighten all hardware down once the bumper is centered.
*If you have a factory trailer hitch there are cutouts in the bumper below the winch
mount so you can bolt the bumper to the hitch for some extra support.
1 2
3
4