Operation 6 – Lukas CT7 User Manual
Page 16
16
DANGER / CAUTION!
Make sure that nobody is present in the danger zone.
Operation
6.
6.1 Setting up the control desk
Control desks must be set up at a safe distance from the load to be lifted or pushed.
Both the load and the implements must be clearly visible from the control desk position.
Make sure that the control desk has stable footing. Use suitable material for support if
necessary.
REMARK:
Set up all other necessary components as described in the separate operating
instructions for these components.
Check that the manual pressure shut-off valve is closed (home position) and then connect
the hydraulic unit to the implements.
6.2 Start-up
CAUTION!
During start-up, observe all information and instructions in the separate operating
instructions for the other components of your rerailing system.
Preparations before start-up:
Before start-up, all components must be visually inspected for damage and leaks. Damaged
components must not be used and must be exchanged.
Hydraulic components must be bled before start-up takes place.
Start-up:
DANGER / CAUTION!
Correctly secure the derailed vehicle against rolling away, slipping and tipping.
Procedure:
1. Set up the necessary components as described in the separate operating instructions for
these components. During set-up, observe all applicable standards, directives, laws and
regulations. Now connect up all hydraulic components as described in the “Connection of
hydraulic devices” chapter.