Lukas CU 4DVV - Manual (Page 14)

14
The support frame ensures secure mounting of the control unit and allows to operator to
work standing upright.
The control unit is delivered in the folded transport position.
Proceed as follows to erect the system (two people required):
1. Lift the control table with the handles at the side. Place your hands in the handles on the
left and right, that are located opposite the locking knob, in each case, in order fi rst to
fold out the lower support frame.
2. Release the support frame lock by pushing the locking knob with your thumb (see
illustration). The support frame swings down up to the stop.
3. Pull the support frame back until the locking knob engages and the system is secure.
4. Proceed in the same way on the second folded support frame.
5. Folding the two support frames is carried out in reverse sequence.
5.1 Folding out the support frame
ATTENTION!
Make sure that the support frame does not hit your knee when it swings down
if you have bent your legs in order to balance the load on your lower arms with
your thighs.