Lukas Double-acting Rope-lift cylinder User Manual
Page 3
3
1
Safety instructions
Designated use of the device
1.1
The cylinders described below may only be used together with LUKAS rerailing equipment
components. It is possible to use the device with equipment made by other manufacturers, however
LUKAS must carry out the technical check and grant approval in each individual case.
1.2
The designated use of the device is exclusively the power supply and control of rerailing
equipment. Any other or additional use, such as the power supply and control of other hydraulic
systems is deemed to be contrary to the designated use. The manufacturer/supplier cannot be
held liable for any damage resulting from such use. The risk of such misuse lies entirely with the
user.
Designated use also includes conforming to the Operating Instructions as well as compliance with
the inspection and maintenance directives (refer to Chapter 4 and Chapter 13).
1.3
The device has been constructed in accordance with the state of the art and the recognised
safety rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties,
or result in damage to the device and to other material property.
1.4
Only use the device when it is in a technically perfect condition, as well as in accordance with
designated use, in awareness of safety and hazards and in compliance with the Operating
Instructions. Any malfunctions, especially those which could affect the safety of the device, should
therefore be rectified immediately.
1.5
Device designation
2
Organisational measures
2.1
Always keep the Operating Instructions ready to hand at the location where the device is
used.
2.2
In addition to the requirements contained in the Operating Instructions, comply with and
provide instruction in the general legal provisions and other mandatory regulations that apply to
accident prevention and environmental protection.
This includes in particular the wearing of working or protective clothing, a helmet with visor or
goggles and protective gloves.
2.3
The device may only be operated by persons who have received appropriate safety training,
otherwise there is a risk of injury. Particular attention must also be to paid to the influence of stress
factors upon operators when the device is being used. These factors may cause a risk to life and
limb of users or of third parties, or result in damage to the device and to other material property.
2.4
Comply with all safety instructions and hazard warnings on the device. Make sure that safety
instructions and hazard warnings displayed on the device are always complete and perfectly
legible.
2.5
Obtain approval from the supplier before making any modifications, additions or conversions
to the device that may reduce safety. This also applies to the installation and adjustment of safety
devices and valves.
HP
25
/
800
R
High-pressure
cylinder
Total stroke
in mm
Hydraulic
retraction
Rated
compression
force
in metric tons