Beam Electrolux Q Power Team - Manual (Page 6)

General Cleaning
The Powerbrush can be wiped with a cloth dampened with warm water and a mild detergent.
1. Do not use abrasive substances.
2. Do not use any solvents.
3. Do not immerse in water or allow water to enter the Powerbrush.
Brush Roller Cleaning
For top cleaning performance, it is recommended that the brush roller and
the brush roller compartment be cleaned on an occasional basis.
WARNING: Always switch off the Powerhead and
disconnect plug from wall outlet and disconnect hose
before servicing the Powerbrush.
1. Turn the Powerbrush upside down.
2. Remove the four screws marked by numbers 1, 2, 3, 4. (see figure 6)
3. Lift base plate up to find belt and brushroll inside. Lift brushroll and,
if necessary, remove old brushroll.
4. The brush roller is now exposed for removal of fibers, hair, etc. from
the bristles and around the brush roller.
5. To remove fibers or hair entangled around the brush roller, cut paral-
lel to brush roller.
6. You may further clean the brush compartment with your central vacu-
um system.
7. Replace the brush cover by inserting the tabs on the front of the cover
into the appropriate slots in the Powerbrush base (as shown in Figure
7) and press down on the front clips until they snap-lock into place.
Then replace the 4 screws.
Figure 6
Figure 7
6