Beam Electrolux Q Power Team - Manual (Page 7)

POWERBRUSH MAINTENANCE
How to Change Poly-V Belt
WARNING: Always switch off the Powerbrush and
disconnect plug from wall electrical outlet and disconnect
the hose before servicing the Powerbrush.
1. Remove the brush cover as described in “Brush Roller Cleaning” steps 1 and 2.
2. Insert a string around the brush roller close to the poly-v belt. Pull both
ends of the string upwards so that the brush roller disengages from the base.
Similarly, disengage the other end. (as shown in Figure 8)
3. Remove and clean the bearing shaft from the brush roller ends.
4. Remove the old belt. (You may also cut the old belt with scissors to
quickly remove it).
5. Slip the new cogged belt over the gear on the motor shaft
(as shown in Figure 9).
6. Now slip the belt onto the brush gear of the brush roller.
(as shown in Figure 10)
7. Slide the bearing housing in the corresponding slots on the base. Make sure
both are completely pushed into place.
8. Replace the Brush cover as described in item 7 under Brush Roller
Cleaning.
POWERBRUSH WARRANTY
Only the superb quality of our Powerbrush makes a warranty like this possible!
• 3 Year Warranty
Within three years from the date of first purchase, should our Powerbrush, including the poly-V belt and LED lamp,
fail to function due to faulty workmanship or material, simply bring it back to your authorized Dealer where they will
replace or repair it (our option).
Figure 8
Figure 9
7
Figure 10