Beko DRVT 61 W - Manual (Page 20)

20 EN
9 Solution suggestions for problems
Problem Cause Explanation / Suggestion
Drying process
takes too much
time.
The filter might have not been
cleaned.
* Meshes of the filter may be clogged.
Wash with water.
Laundry comes
out wet at the end
of drying.
* The filter might have not been
cleaned.
* Excessive laundry might have been
loaded in.
* Meshes of the filter may be clogged.
Wash with water.
* Do not overload the machine.
Machine does not
switch on or the
programme does
not start. Machine
is not activated
when set.
* It might have not been plugged in.
* The loading door may be ajar.
* Programme might have not been set
or the «Start/Pause/Cancel» button
might have not been pressed.
* «Childproof lock» might have been
activated.
* The condenser cover on the models
with a condenser might not be closed
securely.
* Make sure that the machine is plugged in.
* Make sure that the loading door is
properly closed.
* Make sure that the programme has been
set and it is not in “Pause” mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover and
the red lock is closed securely.
Programme has
been interrupted
without any cause.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure that the loading door is
properly closed.
* Press «Start/Pause/Cancel» button to
start the programme.
Laundry has
shrunk, become
felted or
deteriorated.
* A programme suitable for the laundry
type might have not been used.
* Dry only the laundry which is suitable for
drying in your machine after checking the
labels on your clothes.
* Select a programme with suitable low
temperature for the laundry type to dry your
clothes.
Drum light does
not come on.
(for models
equipped with a
lamp)
* The machine might have not been
started by using the On/Off button.
* Bulb may have blown.
* Make sure that the machine is On.
* Call the authorized service to replace the
bulb.
0 / Anti-creasing”
LED flashes.
* The 2-hour anti creasing programme
to prevent laundry from creasing might
have been activated.
* Turn off the machine and take out the
laundry.
0/ Anti-creasing”
LED is on.
* Programme has come to an end.
* Turn off the machine and take out the
laundry.
“Filter cleaning”
LED flashes.
* Filter might have not been cleaned. * Clean the cover filter.
A
Call an authorised service agent if the problem persists.