Mountain Off Road JKTFF - Manual (Page 2)

BEFORE STARTING AND AFTER FENDERS HAVE FINAL PAINT OR POWDER
COATING YOU MUST CLEAN AND WIPE CLEAN THE UNDERSIDE OF THE
FENDER WHERE THE TUBE AND THE TOP SKIN MEET AND ALSO WHERE THE
TOP SKIN AND THE MOUNTING SIDE PLATE MEET. THEN SILICONE THE EN-
TIRE SEAMS TO PREVENT OXIDATION. (SEE PICTURE A & B)
STEP 1:
With the Jeep® on flat level ground, apply the parking brake, Remove
Marker light harness only from front fender. ( see figure 1 )
STEP 2 Remove 4 bolts under fender using a 10mm wrench or socket. ( see figure
2,2a & 2b)
STEP 3: Drill out 6 plastic rivets on the under side of the fender using a 1/4” drill
bit.( see figure 3 )
STEP 4: Pry apart outer fender skin from the inner fender skin apart . (see figure 4)
STEP 5: Remove push in plastic buttons from the wheel well skirt using pliers or
body shop panel tool available at auto part stores. Save these buttons you
will need to temporarily re-use them. (see figures 5).
STEP 6: Use 10 mm wrench to remove bolts which was hidden under the mud
Skirt. (see picture 6)
STEP 7: Use needle nose pliers to squeeze the plastic T keeper and pull plastic
fender away from the body quarter panel (see picture 7,8,9 &10)
Page 2
PICUTUE A PICUTUE B