Mountain Off Road JKTFF User Manual

Page 4

Advertising
background image





STEP 18:
Bolt on the front skirt mounting bracket through the factory hole (see picture
20 and 21).

STEP 19: Bolting on the rear skirt mounting bracket: Hold the rear skirt mounting
bracket against the sloping section of wheel well (see picture 22,23 &24)
and slide the bracket down until your view from the side of the jeep is flush
with the metal wheel well. (see picture 23). Mark the holes thru the bracket
to the Metal wheel well and drill 1/8 holes and mount rear bracket with #8 x
3/4” metal Screw. (see picture 22)

STEP 20: Using hole location 3 as a guide, (picture 25,26) drill thru the inside the
wheel well body with a 11/32 drill bit. Using hole location 4 as a guide,

dimple only

with your drill the inside metal wheel well skin with a 15/32

drill bit. Change drill your bit to a 11/32 drill and drill thru the metal wheel
well skin. (see picture 25&27). De-bur as needed.

STEP 21: With the front and rear wheel well mounting brackets all ready bolted in
place, set the M.O.R.E front fender in position and put the 3/8” x 3/4” bolt up
through the top jeep factory bracket (hole 2) (picture 25) and fasten with
nut, flat and lock washer under the fender. Insert 5/16 x 3/4” bolt with flat
and lock washer in the very bottom rear hole (hole #1, picture 25) to hold
fender up and in a loose in position. Slide the black top trim bracket on the
inside of the body panel. Bolt the rest of holes #1 (in picture 25) with 5/16” x
3/4” long bolts in holes.

STEP 22: With the holes all ready drilled in the metal wheel well from step 20, Insert
spacer #1 approximately 3-3/32” long in hole # 4 (picture 25 & 28) between
the quarter panel and the metal inter wheel well. Insert 5/16 x 4” bolt, fasten
with flat and lock washer and nut. Insert spacer #2 approximately 1-7/32”
long in hole # 3 (picture 25 & 29) between the quarter panel and the metal
inter wheel well. Insert 5/16 x 2” bolt, fasten with flat washer, lock washer
and nut. Insert remaining bolts Tighten down all nuts and
bolts under the fenders

STEP 23: Put the plastic wheel well skirt back in the wheel well. Push the NEW plastic
buttons into the factory locations to hold up the skirt. (see picture 30 & 31).
Push the skirt all the way to the back, left and right. Mark locations to be
drilled thru the supplied front and rear mounting bracket. Drill
the plastic skirt with a 5/16” drill bit. Push in all the new plastic buttons for
final positioning of wheel well skirt.

Page 4

Advertising