Spyclops SPY-DVR16 User Manual User Manual
Page 13
13
3.7 PTZ Setup:
*Note: To control the PTZ, You must connect the wires to the RS-45 port on the back of the DVR
•
Channel: Choose which camera view you want to work with
•
Protocol: Choose the “protocol” required for your device. Both protocols require an additional
RS-485 data cable
•
Device ID: Assign an ID number to each channel (camera view)
•
Baud rate: We suggest using a “baud rate” no higher than 9600 to avoid errors. Please refer to your
cameras specifications for the baud rate that is best for your device
•
Tour position list: This is where you set up each camera “tour”. First, highlight the line in which
you want to add your preset, then click the box with the question mark. Use this box to position the
camera to the desired view, then click store. You then need to assign how you want each position
to hold by selecting “keep time”. If you change a preset, simply click “update” after you are done
reconfiguring. To delete a preset, highlight the tour you want to delete and click “remove”
*Note: You can set up to 32 presets to play back to back
•
To run your tour use your mouse and right click to select “PTZ control” key then click “go to” after
checking “√” the “tour start” box