Synergy 5013 - Jeep JK Rear Coilover Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5013 JK REAR C/O KIT
Version 3
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The installation of the PPM-5013 JK R C/O kit requires minimal cutting and
grinding and a significant amount of welding. An experienced fabricator/welder
is recommended to properly install this bracket.
• Factory coil mounts remain unchanged with this installation and can still be
utilized. This kit can act as a long travel shock mount to mount longer universal
shocks and bypass the factory shock mounts for increased travel and articulation.
• **NOTE**: The installation of this kit requires rerouting of the factory exhaust
and removal of the factory rear sway bar. It is highly recommended this
installation be paired with the installation of a rear Currie Antirock sway bar
(CUR-9900JKRA)
• This kit is designed around fox 2.0” coil-over shocks. If using King 2.0” coil over
shocks, a 90 deg hose end will be needed at the body to prevent contact with the
5013 cross member.
PARTS LIST:
• 1
PPM-5013 JK rear c/o cross member (Fully welded)
• 2
PPM-501302-01 JK rear upper c/o mount outer gussets
• 2 ½-13 UNC 2.75” long bolts
• 2 ½-13 UNC Stover nuts
• 4 ½” flat washers
INSTALLATION:
1) Begin by removing the rear TB bolt and nut at the frame side (#2 in picture
below). This is easiest to do with the vehicle still sitting on the ground under its
own weight.