Synergy 5223 - JK 4 Door B-Pillar Cage Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5223 JK 4 DOOR B-PILLAR CAGE TIE IN KIT
Version 1.1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This is a weld in roll cage kit, all welding should be performed by an experienced
welder with proper welding equipment
• This kit can be used by itself or in conjunction with PPM-5221-A and/or PPM-
5224-A; 4 dr rear cage kit.
• This kit works with either a soft top or hard top.
• Use extreme care when welding and grinding in the interior of your Jeep, remove
or cover any components you do not want welding spatter or grinding sparks to
damage.
1. Remove the hard or soft top, if using a soft top, remove the door surrounds.
2. Remove the sound bar, roll bar covering, and roll bar padding in the B-pillar area.
3. Lastly, remove the carpet in the rear seat passenger foot well area. (This may require
removal of front seats)
4. With carpet removed, reposition front seats (if previously removed) and take note of
any floor insulation in the rear passenger foot well area. Mark out a 4” box from the
edges of the flat portions of the floor near the B-pillar trim.