Synergy 523X - Jeep YJ Cage Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
5231 YJ FRONT CAGE KIT
Version 1.1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference. Fully read through instructions prior to beginning
installation.
• This is a weld in roll cage kit, all welding should be performed by an experienced
welder with proper welding equipment
• Use in conjunction with PPM-5232; YJ rear cage kit. Also, PPM-5233 YJ Side
Cage Kit
• This kit works with either a soft top or hard top
• Use extreme care when welding and grinding in the interior of your Jeep, remove
or cover any components you do not want welding spatter or grinding sparks to
damage.
1) Remove the hard or soft top.
2) Remove the roll cage padding / covers and the rear upper seat belt mounting bolts. It
is also a good idea to remove the rear seat to prevent damage from welding and ease
installation.
3) Install the PPM-5232 YJ Rear Cage kit per the instructions included with the rear
cage kit.
4) Begin by removing the windshield supports on the driver side. Remove the T-50 bolt
on the B-pillar and the 2 T-40 bolts at the windshield. See pics below.