Synergy 523X - Jeep YJ Cage Kit - Manual (Page 5)

8) With sleeve tacked in place, A-pillar fitment can begin. Note that the bottom of the
523101 are cut at an angle and are L&R specific; be sure to install the correct one on
the drivers side.
a. Next, fit the 523102 A-pillar Top tube over the sleeve.
b. Place the cage base plate in the approximate area where the A-pillar
strikes the floor. See pic 8.1b & 8.2b
c. Fit the A-pillar assembly into the Jeep. The notch on the 523102 A-pillar
top tube should just cover the bung for the windshield support tubes. See
pic 8.1c