Synergy 5710 - Jeep JK Standard Skid Plate - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5710 JK HEAVY DUTY SKID PLATE ASSEMBLY
Version 1.1
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com. Check the website before
you begin for any updated instructions and additional photos for your reference.

The installation of this skid plate assembly requires minor cutting, drilling and tapping of threaded
holes.

You have the option to use the factory hex head bolts in the factory skid plate holes or to drill and tap
them and use the supplied flat head allen head bolts.

You will need a 29/64 drill bit and 1/2-20 UNF tap, a grinder with a cutoff wheel or sawzall, and a 7/16”
drill bit.

This skid plate assembly is designed to be used as a complete assembly using none of the factory skid
plates or cross member.
HARDWARE LIST
Qty 5710-01 TRANS SKID HARDWARE
2 FLAT HEAD SOCKET CAP SCREW, 3/8 UNC X 1" L
4 FLAT HEAD SOCKET CAP SCREW 1/2-20 UNF X 1"
2 HEX HEAD SERRATED FLANGE NUT UNC 3/8"
Qty 5710-02 T-CASE HARDWARE
5 FLAT HEAD SOCKET CAP SCREW, 1/2-20 UNF X 1" L
5 FLANGE NUT, SERRATED, 1/2-20 UNF
Qty 5710-03 / 5710-04 OIL PAN HARDWARE
2 FLAT HEAD SOCKET CAP SCREW, 1/2-20 UNF X 1" L
3 FLANGE NUT, SERRATED, 1/2-20 UNF
1 HEX HEAD BOLT, GR 8, 1/2-20 X 1" L
1 1/2" FLAT WASHER
7 HEX HEAD BOLT, UNC, GR 8, 3/8 X 1"
1 SERRATED FLANGE NUT, 3/8-16
7 3/8” SPLIT LOCK WASHER
7 3/8" FLAT WASHER