Synergy 5710 - Jeep JK Standard Skid Plate - Manual (Page 5)

10. Tighten the factory cross member mounting bolts to 35 ft-lbs. Tighten the transmission mounting bolts to
35 ft-lbs
11. Note, some models will require two 7/16” holes to be drilled in the factory gas tank skid for attachment. If
needed use a 7/16 drill bit to drill the gas tank skid plate for the two countersunk mounting bolts in the cross
member skid plate, install the two 3/8 flat head allen bolts with the flange bolts and tighten to 20 ft-lbs