Synergy 5802 - Jeep JK 4 Dr Rear Grab Handle User Manual
Synergy For the car
Advertising
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5802 JK 4 DR REAR GRAB HANDLE KIT
Version 1
GENERAL NOTES:
• It is not necessary to remove the soft top or hard top for installation but it may be
helpful
• The grab handle kit is a bolt on installation but you do have to trim some of
plastic interior trim. A dremel type tool or strait air grinder with a drum sander
works well for this.
1. Remove the seat belt turning loop (2)
2. Remove the upper B-pillar trim panel (1) by pulling toward the center of the vehicle.
The panel is secured with push in retaining pins (2)
Advertising