Synergy 5802 - Jeep JK 4 Dr Rear Grab Handle - Manual (Page 2)

3. Remove side bar padding cover over the rear doors. Remove the over head speaker
pod (2), first remove the hard top thumb screws if equipped, next remove the four
screws (3) and lower the speaker pod. Disconnect the electrical connector (1) and
remove the speaker pod.
4. Remove the upper bolt to the seat belt turning loop height adjuster
5. Loosely fit the grab handles as shown, the bottom bracket of the grab handles goes
underneath the seat belt turning loop height adjuster and the upper bracket of the grab
handle goes underneath the sound bar. Notch the sport bar cross bar padding and cut
a hole for the grab handle to go thru the padding cover.