Synergy 8018 - Jeep JK Synergy Front & Rear Spacer Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8018 Jeep JK Synergy Spacer Kit
General Notes:
● These instructions are also available on our website; www.synergymfg.com. Check the
website before you begin for any updated instructions and additional photo for your
reference.
● These coil spacers are designed to be placed on top of stock coil springs, between the
stock coil retainer.
● Installation tools required: metric wrenches, floor jack, 2 jack stands, and lug wrench.
● We recommend installing rear sway bar drop brackets or longer sway bar links for the
1.75” lift.
Installation instructions:
Front Suspension
1.
Jack up the front of the vehicle and support the vehicle at the frame with
jack stands. Put wheel chocks behind the rear tires.
2. Leave the floor jack under the center of the front axle, it will be used to raise and lower the
axle during installation.
3. Remove the front wheels.
4. Disconnect the front sway bar link at the axle.
5. Disconnect the front shocks at the axle.