Synergy 8018 - Jeep JK Synergy Front & Rear Spacer Kit - Manual (Page 3)

7. With the shocks, sway bar end link and ABS line disconnected, lower
the axle down to remove the coil springs.
8. With the coil spring removed, install the lift spacer over the stock spring isolator.
To clarify, from top to bottom; install the stock spring isolator, then install the lift spacer, then the
coil.
9. Reinstall the coil springs.
10. Raise the axle up to reinstall the shocks, sway bar links and ABS sensor.
11. Reinstall front wheels.
12. Remove Jack stands from front of vehicle.
Rear Suspension
1. Place wheel chalks at the front wheels.
2. Raise the rear suspension and support the vehicle with jack stands at the frame.
3. Remove the rear wheels.
4. Remove the rear sway bar links and shocks at the axle. Unbolt the brackets that hold the rear
brake lines to the outside of the frame.
5. Lower the axle to remove the rear coil springs.
6. With the coil removed, install the rear lift spacer over the stock spring isolator and install the
coil springs. See picture below.