Synergy 8072-03 - JK Weld-On Rear Upper Control Arm Bracket User Manual
Synergy For the car
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
PPM-8072-03 JK REAR UPPER CONTROL
ARM BRACKET
GENERAL NOTES:
• These instructions are also available on our website at www.synergymfg.com
Check the website for any updated instructions and additional photos for
reference.
• This is a weld on bracket and should be installed by an experienced welder.
• We recommend installing one side at a time as to not disrupt pinion angle or
suspension geometry.
INSTRUCTIONS:
1) It is easiest to install these brackets with the suspension sitting at ride height on
jack stands and to remove the following components.
Remove the rear wheels and tires
Remove the rear axle and rear brake assy.
Also remove rear bump stop spacers (if any)
Remove one upper control arm at a time for installation.
2) Begin by removing the stock upper control arm bracket. The bracket is easiest to
remove in 2 pieces. First, make 2 cuts at the top of the welds and one cut down
the side of the stock bracket as shown.