Synergy 8072-03 - JK Weld-On Rear Upper Control Arm Bracket - Manual (Page 3)

4) Next, grind the area smooth and remove all paint and other impurities to prepare
the surface for welding.
5) With the surface cleaned up, fitment of the 8072-03 upper control arm bracket can
begin. We recommend bolting in the upper control arm on the jeep to help with
placement and to ensure no binding will occur with the suspension joints.
6) Fit the bracket in place with the suspension set at ride height.
Slide bracket as far over as possible until it hits the base of the
weld on the axle flange as shown. Do not tack at this time, but
refer to img 6.1 for reference.