Synergy 8069 - Jeep JK Front Track Bar Brace User Manual
Page 14
Advertising
15) With holes aligned, install the 7/16-14 x 1.0” long bolts using a washer under both
the bolt head and the nut. Take note, the orientation of the inner bolt is up to the
installer, however the outer bolts need to use the button head cap screws provided
with the kit to not make contact with the coil spring. Orient hardware as shown
with the nuts pointing in towards the bracket.
a. Do not tighten any bolts at this time; simply start all hardware to finger
tight.
Advertising