Synergy 8080 - Jeep JK Rear Track Bar Bracket Brace User Manual
Synergy For the car
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
PPM-8080 JK R TRACK BAR BRACE
GENERAL NOTES:
These instructions are also available on our website at www.synergymfg.com Check the website for any
updated instructions and additional photos for reference.
Bracket is designed to be bolted on but can be welded on as well if desired.
PARTS LIST:
1 - PPM-8080 JK R TB BRACE
2 - 7/16”-14 UNC 1” long bolt
1 - 7/16”-14 UNC countersunk bolt
3 - 7/16”-14 UNC Stover nut
5 - 7/16” flat washer
1 - ½-13 UNC bolt 1” long
1 - ½-13 UNC Stover nut
2 - ½” flat washer
1 - 9/16”-12 UNC bolt 3.25” long
1 - 9/16”-12 UNC Stover nut
2 - 9/16” flat washer
INSTRUCTIONS:
1) Begin by removing the rear TB bolt and nut at the frame side (#2 in picture below). This is easiest to
do with the vehicle still sitting on the ground under its own weight.