Synergy 8086 - Jeep JK Rear Long Travel Upper Shock Mount - Manual (Page 2)

• 4 -5/16-18 UNC Flange nut
• 4 - 5/16" Flat washer
• 4 - 3/8-16 UNC x 1.25" long bolt
• 4 - 3/8-16 UNC Stover nut
• 8 - 3/8" Flat washer
• 2 – M10 x 1.50 Stover Nut (only used if kit is being used in conjunction with
PPM-8070 Bar Pin Eliminator Kit.
INSTRUCTIONS:
1) Begin by removing the rear shocks from the vehicle. Retain the factory upper
shock bolts as they will be reused in the installation of the new shock mount.
2) Next, start marking out the areas to be cut out of the stock shock mount.
Note- exact cut is up to installer, but for new shock mount to fit, the upper
bent lip of the stock mount must be removed for new mount to sit flush.
Additionally, the frame side tie in of the stock shock mount must be trimmed /
removed.
Picture 2.1 below is a reference cut diagram.
Picture 2.2 below is a finished example of properly trimmed stock
mount.
Picture 2.1 Cut reference