Synergy 8086 - Jeep JK Rear Long Travel Upper Shock Mount - Manual (Page 6)

10) Torque the bolts as follows:
5/16”-18 cross-member bolts = 24 ft-lbs
½” – 13 frame bolt = 80 ft-lbs
Stock Upper Shock bolts = 37 ft-lbs.
11) Next, install the shock into upper shock mount. Orient the 3/8-16 x 1.25”
long bolts as shown below with nut on the bottom side. Use a washer under
both the bolt head and under the stover nut.
12) Torque upper shock bolts to 40 ft-lbs. Reinstall lower shock bolt and
accordingly. Stock bolt; torque to 56 ft-lbs. ½-13 UNC bolt included with
PPM-8078 HD Lower Shock mount; torque to 75 ft-lbs.
13) Lower vehicle to ground and recheck bolts after 100 miles of driving.
The following instructions are for installing PPM-8070 Bar Pin Eliminatior kit in
conjunction with PPM-8086 JK LT Rear Upper Shock Mount.
• Installation pictures are taken with 8086 LT upper mount off the vehicle for
clarity, but install should be done once PPM-8086 is installed in vehicle. (Just
after step 10 above)
• If doing this installation, use the M10 x 1.50 stover nuts included with the PPM-
8086 LT upper shock mount.