Synergy 8094 - Jeep JK Steering Stabilizer Mount (RHD) - Manual (Page 4)

6. Install the two additional 3/8 bolts to the factory track bar bracket. Use a washer
under both the head of the washer and under the head of the nut. Torque these bolts
to 40 ft-lbs (54 N-m)
7. Tighten the track bar bolt to 125 ft-lbs (170 N-m).
8. Install the Poly Performance 8003 Tie rod clamp. Do not tighten yet; you will need
to position the tie rod bracket correctly side to side when the steering stabilizer is
installed.
9. Install the steering stabilizer. If you are using a Fox steering stabilizer, you will need
to use one long (7/16, 11mm) and one short (5/16, 8mm) bearing spacer in the
steering stabilizer relocation bracket. Re-use the factory steering stabilizer bolt and
tighten to 75 ft-lbs (100 N-m).