Synergy 8095-01 - Jeep JK Front Track Bar Brace (RHD) User Manual
Page 11
19) Once adequate clearance has been determined and proper bump stop spacing has
been addressed, fully install the track bar using the 9/16-12 UNC x 3.25” long TB
bolt provided in the 8095-01 kit.
o Be sure to use a washer under both the head of the bolt and under the
washer. Torque bolt to 125 ft-lbs
o Reattach track bar at axle side, follow the mfr’s specifications for torque
specs.
1) Synergy Manufacturing’s 8087 track bar and stock track bar retain
the OEM bolt and is to be torque to 125 ft-lbs.
20) Lastly, grease the bearing in the sector shaft brace using quality chassis grease. 1-
2 pumps is plenty. Re-grease at normal chassis lube intervals or after any severe
mud or deep water fording.
21) Recheck torque specs after the first 100 miles of driving.
22) Installation is complete.