Synergy 8095-01 - Jeep JK Front Track Bar Brace (RHD) - Manual (Page 8)

14) Next, align the outer bolt holes so the 7/16-14 x 1.0” long bolts provided in the kit
can be installed. An alignment bar or screw driver will aide in pulling mount into
proper location.
15) With holes aligned, install the 7/16-14 x 1.0” long flat head socket cap screws
provided in the kit. Use a washer under the head of the nut. Orient hardware as
shown. Do not tighten at this time.
16) Now, install the 7/16-20 UNF x ¾” long bolt into the bracket as shown. Note that
the bracket is threaded and the bolt must be installed from the inside of the factory
track bar mount as shown below. Be sure to use a washer under the head of the
bolt.