Synergy 8554 - 94-02 Dodge Truck Track-Bar Conversion Bracket - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
8554 DODGE TRACK BAR CONVERSION BRACKET
Version 2.0
GENERAL NOTES:

These instructions are also available on our website at www.synergymfg.com. Check the website for any
updated instructions and additional photos for reference.

Bracket is designed to be bolted on with minimal grinding and drilling required.

Designed to be used in conjunction with PPM-8550-02 Adjustable Track Bar.
 Installation requires the use of basic hand tools, a 4.5” angle grinder, and a drill with quality metal drill
bits.
PARTS LIST:

1 - PPM-8507 DODGE TB CONV BRKT

1 – 3/16” thick shim tab

2 - 1/2-13 UNC x 5" hex head bolt

2 -1/2" flat washers

1- 1/2-13 UNC stover nuts

1 - 5/16-18 UNC x 2.5" hex head bolt

1 - 5/16-18 UNC x 2.0" hex head bolt

2 - 5/16-18 UNC stover nuts

4 - 5/16" flat washers

1 - 9/16-12 UNC x 3" hex head bolt

1 - 9/16-12 UNC stover

2 - 9/16" flat washer

1 - 5/8-18 UNF x 2.5" hex head bolt

1 - 5/8-18 UNF nylock nut

1 - 5/8" flat washer
APPROXIMATE INSTALL TIME: 4-6 HOURS (Including track bar)
INSTRUCTIONS:
1) Begin by removing the axle side TB bolt. This is easiest to do when the truck is on the ground and the
weight of the vehicle is on the suspension.