Synergy 8561-03 - Dodge AAM 9 1/4'' 03-13 Lower Control Arm Skid Plate - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
8561-03 – 2003-13 Dodge AAM 9 ¼” Axle
Lower Control Arm Skid Plates
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com. Check the website before
you begin for any updated instructions and additional photos for your reference.

Please read these instructions carefully before beginning, do not attempt to install if you do not have the
tools or skills required.

This is a weld on part and should be installed by an experienced welder.

We recommend installing one side at a time.

Be sure to disconnect the ground cable from the battery prior to welding as to prevent electrical damage
to the vehicle.
PARTS LIST:
 (2) 8561-03 DODGE LOWER CONTROL ARM SKIP PLATE 2010- PRESENT (1R & 1L)
Parts / Tools Needed to complete installation:

Basic simple hand tools.

4-1/2” angle grinder with cut off wheel and abrasive attachments to remove paint and metal from inner
C’s.

Some form of welder. Mig is preferred, but Tig or stick welding is acceptable.

Spray paint of desired color.
APPROXIMATE INSTALL TIME: 2-4 HOURS
INSTALLATION:
1) NOTE: This install can be done with the vehicle on the ground under its own weight. However, the
vehicle can be raised off the ground for easier access. Be sure to use a quality jack and jackstands.
2) Begin by cutting off the factory gusset that spans the front of the lower control arm bracket circled
below.