sPOD 1997-2002 Instructions Center Bracket - Manual (Page 3)

8) Route the wires to the passenger side and down the pillar
through the dash (photo 8). Then re-tighten 3 pillar screws
loosened in step 4 & re-install visor.
Photo 8
9) Remove the glove box & route the wires out of the way
(photo 9).
Photo 9
10) Mark the lower right portion of the firewall for drilling
below glove box (photo 10).Drill a 1" hole in firewall. Be sure
to check the opposite side for any obstructions prior to
drilling (photo 10a).
Photo 10
Photo 10a
11) De-burr the hole and install the rubber grommet over
harness connector. Feed the connector & harness through
the firewall, then seat the grommet (photo 11).
Photo 11