sPOD 1997-2002 Instructions Center Bracket - Manual (Page 4)

12) Re-install the battery (photo 12).
Photo 12
13) Remove the 4 screws attaching the power source to the
mounting bracket (photo 13).
Photo 13
14) Loosen the 3 T-20 torx screws attaching the ECU just
above the battery (photo 14).
Photo 14
15) Slide the mounting plate behind the ECU torx mounting
screws and tighten (photo 15).
Photo 15
16) Re-install the power source to the mounting bracket
(photo 16).
Photo 16
17) Route switch harness through opening on power source
and attach (photo 17).
Photo 17