Smittybilt CN1920-S4x Sure Steps - Manual (Page 2)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Sure-Step (Part # CN1920-S4x)
01-07 Chevrolet / GMC Silverado / Sierra Crew Cab,
Including HD.
Step 2: Secure the side bar to the front and rear brackets using the 12mm x 50mm Hex Bolts, Lock washers and
Flat Washers provided. Secure the Center Bracket to the Side Bar using 8mm x 25mm Hex Bolts, Lock washers
and Flat washers provided. After checking to make sure the sidebar is level and square with the side of the
vehicle, completely tighten all hardware.
Step 3: Repeat steps one and two on opposite side of vehicle. Installation is now complete.
Product cleaning and maintenance instructions
Stainless Steel Finish – Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap,
window or glass cleaner may be used to clean the finish. Dual state powder coat finish – Mild soap, window or glass
cleaner may be used to clean the finish. In order to protect the finish, you may wax your product on a regular basis with
pure carnauba automotive wax. Do not use any types of soap, polish or was that contains abrasive that could damage
the finish. Textured coated finishes should be cleaned with a mild soap on a damp sponge. Do not apply polish or
was that requires to be removed by means of buffing. This type of wax is commonly used at car wash facilities.
Chrome Finish – Mild soap, window or glass cleaner may be used to clean the finish. In order to protect the finish you
should wax your product on a regular basis with pure carnauba automotive wax. Do not use any types of soap, polish or
was that contains abrasive that could damage the finish.
Limited Warranties
Front
Bracket
Center
Bracket
Rear
Bracket
120mm Bolt
25mm Bolt
120mm
Bolt
50mm
Bolt
120mm
Bolt
50mm Bolt
Figure 1 Figure 2 Figure 3
Note: Brackets may vary slightly than ones pictured.