Smittybilt SB76654 Rear Bumper - Manual (Page 8)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Revised 12.09.09
Installation Instructions:
(Part # SB76654)
87-06 Jeep TJ/YJ XRC Tire Carrier
guide to mark and drill the OE brake light plastic housing. Drill the plastic housing using an
11/32” drill bit. (Fig. J) NOTE: The 3rd brake light plastic housing will not sit flush
against the bottom of the 3rd brake light bracket (93-5663).
Step 4: Secure the OE plastic housing to the 3rd brake light bracket (93-5663) using the
supplied (3) 5/16” X 1” bolts and hardware. (Fig. J)
IMPORTANT!: Do not over tighten these bolts.
Step 5: Reconnect the 3rd brake light wiring harness.
NOTE: It is recommended to extend the 3rd brake light wiring harness. This can simply
be done by splicing the wire and using some insulated butt splice connectors and 18 gauge
wire, extend the wire to the appropriate length. It is recommended to have this done by an
experienced electrical installer.
Step 6: Installation of the third brake light assembly is now complete.
OE 3rd Brake
Light Housing
93-5663 3rd
Brake Light
Bracket
11/32”
Drill Bit
5/16” X
1” bolts
(Fig J) Be sure the housing sits
flush against the back
of the bracket