Addictive Desert Designs 2009 - 2013 F-150 Series LED Light Strip - Manual (Page 2)

INSTALLATION INSTRUCTIONS
1. Carefully remove the passenger side kick panel, fuse block
panel and side dash panel. These are held in by clips, so please
use care not to cause damage to plastic components.
2. Locate ¾” hole covered with tape. Cut hole
in the tape with knife and route end of
harness with blue tap connector and
ground eyelet through bottom of truck into
the cab.
3. Route harness diagonally from hole toward
green plug located beside the fuse box.
4. Use Blue Tap to and clip onto dome light circuit wire coming from pin #5. (Color of wire changes
between models, so find pin designation on green plug)